1991 DODGE CARAVAN MINIVAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) RT OF STEERING COLUMN AT BODY COMP PIN#2
TrunkTrigger TAN/BLK (-) (-) DRV KICK,BRN/YEL(-) DRV RUN BRD"SLD DOOR
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BLK/YEL (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety BRN/YEL (-) AT SWITCH ON TRANSAXLE
Tach BLK/GRY (-) (-) OR GRY (-) AT COIL PACK
SpeedSense WHT/ORN (AC) WIRE HARNESS FROM TRANSMISSION
ParkingLights BLK/YEL (+) AT LIGHT SWITCH
BrakeLights WHT/TAN (+) AT BRAKE SWITCH
ReverseLights VIO/BLK(+) (+) AT SWITCH ON TRANSAXLE
Horn BLK/RED (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/VIO (+) POSITIVE TRIGGER
PowerLock ORN/WHT (+) BEHIND FUSEBOX AT DOOR LOCK RELAYS
LeftFrontWindow01 LF=LT BLU
RightFrontWindow01 RF=BRN/WHT
Convenience
HeadLights ORN/WHT (+) AT LIGHT SWITCH
LowSpeedWipers RED/YEL (-) AT STEERING COLUMN
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/ORN + (+) IGNITION SWITCH HARNESS
Ground -
Illumination BLK/YEL (+) RADIO HARNESS
PowerAntenna YEL (+) RADIO HARNESS
FrontLeftSpeakerPos DK.GRN
FrontLeftSpeakerNeg DK.GRN/RED
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg VIOLET/YELLOW
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/LT.YEL
RearRightSpeakerPos DK.BLU/WHT
RearRightSpeakerNeg DK.BLU/ORN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
